
30% Solids Clear
Outdoor Concrete Sealer
High-Performance Silane 30% Solids Sealer




Durável DV-30 is a High-Performance Silane 30% solids Methyl-Methacrylate Acrylic clear concrete sealer providing excellent color enhancement with a non-yellowing crystal-clear finish. DV-30 is high gloss, color enhancing and formula.
Durável DV-30 uses the latest technology for superior bond to concrete and overlay. The addition of an Advanced Silane Composition promotes adhesion, increases mar resistance, and makes recoating easier. Pure Methyl-Methacrylate Acrylics protect concrete against damaging effects of UV rays, traffic, weather, deicing salts as well as improving stain resistance from many chemicals. Use DV-30 on natural and colored concrete, stamped concrete, and decorative overlay. It is vapor permeable yet reduces the penetration of fluids into the surface. DV-30 will enhance the beauty of concrete, improve stain and abrasion resistance, and provide protection for driveways, walkways, patios, porches, balconies, and other surfaces from common stains and chemical attack. Also available in < 400 g/L VOC formula.
Coverage
Usage will vary with application. Typically, one gallon of product will cover about 180-200 square feet of concrete or overlay depending on the porosity. Apply in two coats for new work, or as a single protective coat over existing compatible sealer.
Typical Uses
Crystal clear concrete sealer to protect
Natural concrete and overlays
Driveways, walks and patios
Porches and balconies
Commercial and residential concrete
Product Advantages
UV-stable pure acrylics
Superior bond to concrete and overlay
Protection from stains and chemicals
Resists salts, acidic stains, and other damage
Mar resistant High Gloss finish
MIXING INSTRUCTIONS
DV-30 is a single component solvent acrylic sealer. Material should be stirred well prior to application. Long term storage may allow material to separate.
APPLICATION INSTRUCTIONS
DV-30 may be rolled using a 1/2″ or 3/4″ nap roller. Select a nap length appropriate to not leave excess sealer in low parts of the concrete texture. Application may also be done using a solvent resistant sprayer designed for this use; back roll as needed to remove excess sealer in low parts of the concrete texture. Sealer should be applied in thin coats.
Cured Physical Properties
Re-coat……………………………………………. 2 to 24 hours
Flash point (tag closed cup) ………………. 65 °F (18 °C)
Solvent resistance…………………………….. minimal
Typical Data at 75 degrees
Dry to touch ………………………………………….. 25-60 minutes
Foot traffic ……………………………………………. 24 hours
Vehicle traffic ……………………………………. 4-5 days
VOC content………………………………………….. < 600 g/L or < 400 g/L
Adhesion to concrete………………………………. excellent
Resistance to yellowing from UV exposure… excellent
Solids content………………………………………… 30% by volume
Low concrete or air temperature and/or high relative humidity will extend drying time.





