Clear Floor Epoxy for Metallic Coatings - E100 Plus

E-100 PLUS Epoxy

Extended Open Time 100% Solids Epoxy

E-100 PLUS is a long pot life 100% solids cyclo-aliphatic epoxy with extended working time on the floor and superior self-leveling. E-100 PLUS is a water-clear finish that will resist ambering over time. E-100 Plus was designed for the addition of Metallic VR pearl pigments for a metallic flooring system.

Quick Facts: E-100 PLUS Epoxy

Solids Content (weight) – 100%

Dry Time, Tack Free – 11 to 13 hours

Dry Time, Foot Traffic – 20 to 24 hours

Dry Time, Heavy Traffic – 2 to 7 days

Recoat Window – 12 to 24 hours

Pot Life @ 72⁰ F – 25 Minutes

Application Temperature: 
Substrate – 50° to 80° F

VOC – less than 50 g/L

 Packaging:

3-Gallon Kits

COVERAGE  

Typical coverages are as follows for E-100 PLUS:

160 sq ft per gallon for 10 mil DFT (Primer)

100 sq ft per gallon for 16 mils DFT (Build Coat)

40-80 sq ft per gallon for 20-40 mils DFT (Metallic)

 

TYPICAL USES of E-100 PLUS Epoxy:

Versatile Epoxy that can be used in Industrial, Commercial, and Residential applications such as:

Education and Stadium Facilities

Warehouse and Office Space

Manufacturing and Workshops

Retail Flooring and Restaurants

Healthcare and Hospitals

PRODUCT ADVANTAGES of E-100 PLUS

Versatile Self-Leveling Formula

45 Minute Pot Life at 70° F Ambient Temperature

Slower Set Times to Allow for Enhanced Metallics Movement

Water Clear with High Reflectivity

Low Odor and VOC Compliant

MIXING INSTRUCTIONS 

If less than full kits will be mixed, each component should be mixed thoroughly with individual tools. Using the same tool to mix part A and Part B will cause contamination and ruin the material being saved for future use. E-100 Plus is to be mixed at a ratio of 3 parts A to 1 part B. In clean mixing containers pour the correct ratio in and mechanically mix for 3 minutes using a jiffy-style mixer. DO NOT USE A STIR STICK! The amount of material mixed should only be what can be utilized within the listed pot life of the product. When mixing a 3-gallon kit, the Part A pail may be used as the mixing container.

APPLICATION INSTRUCTIONS 

Do not leave mixed material in the mixing container. The mixed product should be poured onto the floor in ribbons then spread and backrolled. A flat or notched squeegee is the most efficient method to quickly get the material across the floor. Do not over-work the product.

RECOAT: Recoat time listed above is directly affected by the ambient surface temperature. Apply additional coatings as early in the recoat window as possible for the best results. Even within the recoat window, it is recommended to abrade and clean the existing coat. If the recoat window has passed, it is critical to thoroughly abrade the surface with 80 to 120 grit sanding screens. Thoroughly clean the existing coating before abrading to remove potential contaminants.