Restore-A-Seal™-Side-by-Side

D-Grip™

Slip Resistance Additive

D-Grip micronized polymer traction additive provides increased slip-fall protection when added to a range of solvent base concrete floor coatings. There are three sizes: D-Grip (40 mesh), D-Grip Fine (100 mesh) and D-Grip HD (16 mesh). Unlike typical polypropylene products, the clear polymer of D-Grip does not significantly reduce the gloss or color of sealer. D-Grip mixes easily into solvent sealers and stays suspended with minimal additional stirring. 

TYPICAL USES of D-Grip™

Available in three sizes:

D-Grip Fine: Fine 100 mesh 

D-Grip: Standard 40 mesh 

D-Grip HD: Heavy Duty 16 mesh 

Provides safe slip-fall protection on: 

  • Swimming Pool Decks 
  • Driveways and Sidewalks 
  • Stamped Concrete 
  • Patios and Garages
  • Other Interior and Exterior Surfaces 

PRODUCT ADVANTAGES of D-Grip™

  • Mixes Easily and Stays Suspended 
  • Only Slight Loss of Gloss
  • Range of Sizes 

    MIXING INSTRUCTIONS 

    Blend up to six ounces of D-Grip per gallon of solvent base sealer or coating. Stir well without introducing air into the product. In larger volume, it may be necessary to stir occasionally during application. 

    APPLICATION INSTRUCTIONS 

    Roll sealer or coating per that product’s TDS instructions. If used in conjunction with water base product it is recommended to broadcast D-Grip into the wet coating and backroll to encapsulate the additive.