ASTM 1315 Concrete Cure and Seal for New Stamped Concrete ASTM 309

First Day PLUS™

ASTM 1315 Concrete Cure and Seal
High Gloss Pure Acrylic Sealer for New Concrete

ASTM 1315 Concrete Cure and Seal for New Stamped Concrete ASTM 309

First Day Plus is a high gloss pure acrylic sealer for fresh poured concrete and resealing – Cure and Seal. The MMA-enhanced 25% solids formula allows concrete to hydrate properly and increased protection from salt, rain, ice, and inclement weather that typically damages concrete. Meets ASTM 1315 Requirements.

Durával TRO – Don’t Just Seal it… Durável It!


Quick Facts: First Day PLUS™

Solids Content – 25% by weight

Dry Time, Tack Free – 1 to 2 hours

Dry Time, Foot Traffic – 4 to 6 hours

Dry Time, Heavy Traffic – 24 to 48 hours

Recoat Interval – 4 to 24 hours

Application Temperature, Substrate – 50° to 80° F

VOC Content – < 700 g/L

COVERAGE  

First coat: 250 – 350 sq ft per gallon

Second Coat: 300 – 400 sq ft per gallon

Coverage rates will vary greatly depending on surface porosity and application method. Avoid a thick build of First Day Plus. Product is designed to be used as thin coats and is not to be built up.

 

TYPICAL USES of First Day PLUS™

Stamped Concrete

Overlay Products

Stained Concrete

Exposed Aggregate

Broom Finish Concrete

Request More Information

MIXING INSTRUCTIONS 

First Day Plus is a single component solvent acrylic sealer. Material should be stirred well prior to application. Long term storage may allow material to separate.

APPLICATION INSTRUCTIONS 

First Day Plus may be applied as soon as concrete can support weight for its first coat after the placement process. Application should be done using a solvent resistant sprayer designed for this use. First Day Plus may also be rolled using a ½” or 3/4” nap roller. Sealer should be applied in thin coats.

ASTM 1315 Concrete Cure and Seal for New Stamped Concrete ASTM 309

Duravel Clear Concrete Acrylic Sealers and Cure and Seal