Traction Additives for Sealers and Coatings
D-Grip:
Non-Slip Traction Additive – 50 Mesh
D-Grip HD:
Heavy Duty Traction Additive – 20 Mesh
Blend up to six ounces of D-Grip per gallon into topcoat prior to application. When used in single-component products D-Grip can be blended in the original sealer container. Two-component products should first be mixed for the time recommended on their TDS prior to adding D-Grip. Stir well without introducing air into the product. In larger volumes, it may be necessary to stir occasionally during application.
Durával D-Grip™ – Don’t Just Do it… Durável It!
The just-add-water mix is self-bonding and cures to over 6,000 PSI. Durával TRO will handle all residential and commercial traffic, including forklifts. Durável TRO is installed on parking lots, parking decks, driveways, sidewalks, commercial entrances, and other exterior and interior horizontal surfaces. The overlay is installed with conventional concrete tools. Finish options include smooth trowel, broom texture, and a range of decorative textures. The single-component bag mixes are available in three formulations: Light Grey, Dark Gray, and White. Durável TRO White may be field tinted to over twenty decorative colors.
- Mixes Easily and Stays Suspended
- Only Slight Loss of Gloss
- 20 Mesh and 50 Mesh
Product Description:
D-Grip micronized polymer traction additive provides increased slip-fall protection when added to a range of concrete floor coatings. There are two sizes: D-Grip (50 mesh), and D-Grip HD (20 mesh). D-Grip mixes easily into sealers and coatings and stays suspended with minimal additional stirring.
Typical Uses: Provides safe slip-fall protection on:
- Swimming Pool Decks
- Driveways and Sidewalks
- Stamped Concrete
- Patios and Garages
- Other Interior and Exterior Surfaces
Product Advantages
- Mixes Easily and Stays Suspended
- Only Slight Loss of Gloss
- Range of Sizes
Packaging:
30 ounce bottle
MIXING INSTRUCTIONS:
Blend up to six ounces of D-Grip per gallon into topcoat prior to application. When used in single-component products D-Grip can be blended in the original sealer container. Two-component products should first be mixed for the time recommended on their TDS prior to adding D-Grip. Stir well without introducing air into the product. In larger volumes, it may be necessary to stir occasionally during application.
